BlackLX
06-27-2004, 05:21 PM
I took out the crank pully and put the sleve and powerdyne crank pully back on.
The bolts don't seem to go in all the way...there is about 1/4 in. of play the pullies can be slid forward. When I try to tighten it, it turns the crank and car moves.
Any suggestions....i was thinking the bolts I got with it are a bit too long. I am unsure if i should just put some washers on it or what since the bolts are sticking out a bit yet.
The bolts don't seem to go in all the way...there is about 1/4 in. of play the pullies can be slid forward. When I try to tighten it, it turns the crank and car moves.
Any suggestions....i was thinking the bolts I got with it are a bit too long. I am unsure if i should just put some washers on it or what since the bolts are sticking out a bit yet.