this weekends little project

[smokin'Red35th]

Tomorrow morning Dawn and I will be doing some work to the stang. We have a centerforce dual friction clutch, spec billet steel flywheel, and aluminum driveshaft to install. if we have time we'll also try to install the steeda rear lower control arms that have been sitting in a box for over a year and a half now.
cant wait! :rockon:

[clayton bigsby]

hope it all goes good.

[MrsSmokin'Red35th]

It should, hes got a lot of stang guys that are gonna help out. I actully have to work, yucky!!!

[Tim Russell]

since you on the other side of the world is it righty loosey lefty tighty. good luck have fun


Naw, that's in roo land where everything is backwards. :thumbs_up

[markstang]

since you on the other side of the world is it righty loosey lefty tighty. good luck have fun





your pretty funny coopster....... good luck on the install. :shifter:

[JORGE]

good luck on the install and have fun

[Fatstang]

Nice, I am looking for the same clutch set up for my car once the nitrous eats up my factory clutch!

[1slo5.0]

Nice and shiny parts. I'd be afraid to get them dirty :D

[smokin'Red35th]

thanks guys. the install went pretty well. had some issues with the top bellhousing bolts :mad: but nothing an impact gun, swivel, and a bunch of extensions wouldnt take care of :rockon:

but anyway, we got the new flywheel, clutch, and driveshaft in and its workin pretty well. hard as hell to stay off the gas though to break the clutch in. i got the new control arms in as well and i want to try them out, but i cant :(

[smokin'Red35th]

If you dont mind, how much did you pay for the driveshaft?
i think it was like $249.00 or something like that. got it from summit as well as the clutch.