Machining 4.6 Alum. block

[sacstoy02gt]

Anyone ever had a Teksid or WAP aluminum block machined? If you have, who did it, and how much did it run you? Likely would get it bored .020 over as well.

Thanks in advance! Just gathering info here...nothing in the works at all :p

edit: If the block is low-mileage, would machining even be needed at all? hone cylinders, drop in new balanced rotating assembly and go?

engine building super-newbie here

[PER Race Engines]

yes i have them and i run a alun 5.4 block for cost give me a call 815-254-2333 thanks randy

[sacstoy02gt]

Thanks for the info Randy!!

[Kirk]

He beat me to the post But, I was going to say talk with Randy. :thumbs_up