PDA

View Full Version : Programming - Keyless Entry Remote Transmitter


Kirk
04-02-2004, 01:25 PM
Programming - Keyless Entry Remote Transmitter

Note:
This procedure is for a 2000.
All keyless entry remote transmitters (15K601) must be programmed at the same time.
Note:
All previous transmitter identification codes (TIC's) will be erased when programming mode is entered.
Note:
To program (or reprogram) the keyless entry remote transmitters into the generic electronic module (GEM)(14B204), perform the following steps.

Procedure:

1. Turn the ignition from OFF to RUN eight times within 10 seconds, ending in RUN. If the GEM has successfully entered program mode, it will lock and unlock all the doors.

Note:
The first TIC must be entered within 7.5 seconds of entering the program mode and additional TICs must be entered within 7.5 seconds of the first TIC. The programming mode is exited whenever the timing constraints are not met.

2. Press any button on a keyless entry remote transmitter, and the doors will lock and then unlock to confirm that each keyless entry remote transmitter has been programmed.

3. If the door locks do not respond for any keyless entry remote transmitter, wait for several seconds and press the button again.


4. Turn the ignition switch to the OFF position, or wait up to five minutes after step 1, to exit program mode. If a keyless entry remote transmitter has been programmed (or reprogrammed), the GEM will lock and unlock all the doors one last time.

zero
03-04-2005, 12:35 AM
or that lil clip in your trunk on drivers side, it looks like an unplugged peice attached onto a black plastic thing, use a screw driver or key to jump the jumpers (make sure your key is in ignition and turned onto on position)
then u will hear door lock an unlock, now press any button on all keyless remotes you have for the car, even your present remote even if it worked, you need to press a button on it when the doors lock and unlock.
This is what I did to program my 98 v6, works on mustangs this way.